顶进过程（Jacking process）.docVIP

顶进过程（Jacking process） A brief introduction to the method: The construction process of drilling pipe method The geological survey, through the curve design, measuring the magnetic azimuth, and driller drill guide hole, reaming, dragging, environmental protection, landscape restoration The working principle of drilling pipe method The working principle of horizontal directional drill is: in the construction, in accordance with the drilling trajectory design (usually curved), drill a hole can be used to guide the approximate horizontal drilling rig from the surface, then the guide bit changed after the large diameter drill hole and drill head diameter less than to be laying pipeline. Then reverse reaming, will also pull back into the pipeline to be laid in the borehole, when all the drill was towed back to work at the same time, the pipe laying is completed. This project adopts graded reaming according to the geological conditions, is divided into 2 hole, back to the method of pipeline crossing construction of drag. The equipment in place, installation and debugging. On the construction site of smooth driller before (20m * 30m), to ensure that equipment and import traffic field. Equipment and material storage area must be higher than the natural ground of not less than 15cm, leveling, compaction, side ditch and cross section of not less than 0.3m * 0.3m. Lay the axis line, combined with the actual situation according to the angle, the buried buried drill accurately in place. Rig equipment, equipment, mud solid control equipment after installation, commissioning, inspection, testing equipment, to ensure the safe operation of equipment. To control the equipment after installation, debugging, to ensure the accuracy of the guide hole. At the end of the mud pit and buried (2m * 4m * 2m) and the end of the mud pit unearthed storage (2m * 3M * 2m). The excess mud centralized removal by suction sewage truck. Slurry storage pit (2m * 4m * 2m) and the end of the mud pit unearthe