高层公寓框支剪力墙结构设计的几项措施（High-rise frame supported shear wall structure design measures）.docVIP

高层公寓框支剪力墙结构设计的几项措施（High-rise frame supported shear wall structure design measures） High-rise frame supported shear wall structure design of several measures of.Txt High-rise frame supported shear wall structure design measures The frame supported shear wall structure, stiffness, component discontinuity, force transfer complex, under the earthquake frame layer will produce a great deal of internal force and plastic deformation, poor seismic performance, easy to cause damage; conversion layer complex stress, material consumption, heavy, complex construction. The cost is high, but the frame supported shear wall structure can meet the building, under the different functions of the combination. The construction scheme is determined, in order to improve the seismic performance, reduce weight and save investment, consider the following problems of the design of Engineering structures. The 1 upper shear wall system 1.1 reduce the weight of structure Reduce the weight of structure, can directly reduce the amount of concrete, and reduce the vertical load and horizontal seismic force, further reducing the internal force of the structure, improve the economic indicators, especially the foundation and conversion layer of concrete and steel consumption. 1.1.1 floor The floor covering the entire building area, reduce the thickness of the floor slab is the concrete reduced amount per square meter construction area of the. The slab thickness control in the ratio of thickness and span plate meet the requirements, and meet the small fire and embedded pipeline required value is 100 mm, with the lowest consumption of concrete. 1.1.2 shear wall In considering the floor at the same time considering the shear wall concrete consumption at least. According to the spacing enlarged shear wall, the wall will be part of bay light partition replaced, can effectively reduce the amount of concrete. As the board does not increase the span, make the thickness of 100 mm can be achieved, in the wall be