旁路电容(英文PDF6).pdfVIP

TN-00-06 BYPASS CAPACITOR SELECTION TECHNICAL BYPASS CAPACITOR NOTE SELECTION FOR HIGH- SPEED DESIGNS This article was originally published in 1996. and resistance (R1, Rg2, L2, Lg2 in Figure 1) so that transient currents flowing across the power bus do not INTRODUCTION cause excessive noise at the power and ground pins of In order to guarantee better performance from high- the IC. Therefore, the bypass capacitor should have low speed digital integrated circuits (ICs), manufacturers effective series resistance (ESR) and series inductance are tightening power supply noise margins. With lower while having a large enough capacitance value to power supply noise margins, the designer needs to pay supply current to the IC during switching. closer attention to local bypass capacitor selection. Several factors need to be considered when selecting As bus speeds increase and switching times decrease, local bypass capacitors. These factors include selecting proper selection of local bypass capacitors for high- the proper capacitor value, dielectric material, geom- speed digital ICs is becoming increasingly complex. etry and the location of the capacitor in relation to the With wider parts becoming prevalent in cache sub- IC. Careful observance of fundamental principles will systems, the amount of c