ansys弯矩图（ansys弯矩图）.docVIP

ansys弯矩图（ansys弯矩图） ANSYS bending moment diagram 1. draw the bending moment diagram Establishment of bending element table. Beam element The I node cell table name is IMOM, and the j node element table name is jmom, ETABLE, NI, SMISC, 1, unit I, point axis force ETABLE, NJ, SMISC, 7, unit J, point axis force ETABLE, QI, SMISC, 2, unit I point shear ETABLE, QJ, SMISC, 8, unit J point shear ETABLE, MI, SMISC, 6, unit I point bending moment ETABLE, MJ, SMISC, 12, unit J point bending moment PLLs, MI, MJ 2. mark the bending moment diagram PLOTCTRLSNUMBERINGSVAL ON can draw the moment diagram and mark the value of the moment value on the diagram 3. adjusting bending moment diagram If the bending moment is in the wrong direction, the bending moment diagram is plotted as PLLs, IMOM, jmom, -1 There is a slight difference in the forces between the two sides of the same node, Cause internal force digital annotation to appear ghosting. It is also possible to observe the whole axis, It looks like a mosaic, but the overall bending moment is also true, but its not Obviously. This is caused by the EULER-BEONOULI beam theory and the ANSYS output definition The reason for that is not going on, take a look at the book of Liangs theory and ANSYSs explanation. In order to correct the problem of ghosting and different values of the internal forces on both sides of the node, the macro file ITFAVG.MAC is passed The command file reads as follows: ---------------------------------------------------------------------! Macro: ITFAVG.MAC (INTERNAL, FORCE, AVERAGE, MACRO) Get the internal forces of the linear unit and balance the internal forces at the boundary of the element Enter the information Internal force types: MFORX, MFORY, MFORZ, MMOMX, MMOMY, MMOMZ *ASK, ITFTYPE,PLEASE, INPUT, THE, TYPE, OF, INTERNAL, FORCE,MMOMY Unit package to be processed *ASK, EASSEMBLY,PLEASE, INPUT, THE, COMPONENT, NAME, OF, ELEMENTS, TO, BE, PROCESSED,.., EOUTER Node package to be processed *ASK, NASSEMBLY,PLEA