apds_hlp（apds _ hlp）.docVIP

apds_hlp（apds _ hlp） Highway asphalt pavement design and checking procedures, main window instructions 1. program function (1) the traffic volume on the left side of the window frame, there are two radio buttons, when the user selects the direct input of cumulative equivalent axle radio button, can directly enter the cumulative equivalent axle; when the user selects the calculation of cumulative equivalent axle radio button in the usual steps, then the program according to the vehicle the first input traffic parameters and traffic conversion, and then worked out the first year on average two operational standard axle load and equivalent axle design within the duration of a lane on the cumulative equivalent axle. In the calculation of traffic volume, the program requires the user to input the annual growth rate of the traffic section number NM. When NM=1, the program calculates the accumulative equivalent axis according to the average annual increase rate of traffic volume. When NM1, the program calculates the accumulative equivalent axis according to the annual growth rate of traffic volume. At the same time, the daily average traffic volume of buses and medium-sized trucks is calculated. On this basis, according to the highway asphalt pavement design specifications (hereinafter referred to as norms) 3.1.8, determine the level of pavement design traffic. (2) in the upper right corner of the window pavementdesign frame, when the user selects the design according to the design deflection value radio button, on the basis of the above calculation program, further calculates the pavement deflection value; when the user selects the design according to the deflection value and allowable stress design the radio button, the program not only calculate the deflection of pavement design, it will calculate the asphalt concrete pavement (mastic asphalt macadam layer, asphalt macadam) and semi rigid base and subbase material allowable tensile stress. (3) according to the design pa