arm的开发步骤（The development of arm steps）.docVIP

arm的开发步骤（The development of arm steps） ARM development steps 1. a minimum system board: if you havent done the development of ARM, it is recommended that you do not Tandaqiuquan start, all the applications are good, because the starting mode of the ARM and DSP MCU or different, often encounter all sorts of problems, it is recommended to a small system board SRAM is only Flash. SDRAM, CPU, or JTAG, and reset signals, set aside interface. The minimum system can run normally, your task is half done, but ARM peripheral interface are the standard interface, if the hardware you have experienced, this is a very easy thing for you. 2. write the boot code, and write a small code that starts according to the hardware address, including the following: Initializes the port, interrupts the interruption, copies the program to the SRAM, completes the remapping of the code, configure the interrupt handle, and connect to the C language entry. You may see some examples to your program, bootloader will have a lot of things, but dont be bothered by these complex procedures, because you do not board, your task is to do some small programs, so that your application can run. 3., carefully study the data of your chip, and although ARM is compatible with the kernel, each chip has its own features. You must consider these issues when writing programs. Especially girls, here must not rely on psychology, always want to take other peoples sample procedures modify, but the more change the more chaotic. 4. see some operating system procedures, the application of the ARM open source program, in order to improve yourself, to see someone elses program, Linux, uc/os-II and so on. These are all good original code. 6., if you are the hardware, each manufacturer basically has the DEMO board schematic diagram for the chip. Digest the schematic first. So you do design later, the allocation of resources know fairly well. The devices DATSHEET must be well digested. 7., if you do software, it is best to unde