lc和rc比较（Comparison of LC and RC）.docVIP

lc和rc比较（Comparison of LC and RC） One, excuse me, imitate power supply place filter, often use LC circuit. But, I find that sometimes LC is worse than RC filter. Why is that, and what is the method of capacitance and inductance in the filter? Answer: LC and RC filter effect comparison, must consider to filter out the frequency band and the inductance value, whether the choice is appropriate. Because the size of inductance inductance and inductance and frequency. If the power noise frequency is low and the inductance is not large enough, the filtering effect may not be as good as that of RC. However, the cost of using RC filtering is that the resistor itself will consume energy, reduce efficiency, and be careful that the selected resistor can withstand the power. In addition to considering the noise frequency and the instantaneous current response capability, the inductance value should be considered. If the LC output will have a chance to output high current at an instant, the inductance will prevent the current from flowing through the inductor, increasing ripple noise. The capacitance value is related to the magnitude of the tolerable ripple noise specifications. The smaller the ripple noise requirement, the greater the capacitor value. The capacitor ESR/ESL will also have an impact. In addition, if the LC is placed at the output of the switching power supply, it is also noted that the pole zero point (pole/zero) generated by this LC affects the stability of the negative feedback control loop. In two, the size of the circuit board fixed, if you need to accommodate more functional design, often need to increase the PCB line density, but this may lead to line interference enhancement, and walk the line or make impedance can not be reduced, please experts at high speed ( 100MHz) high density PCB design skills? Answer: in the design of high speed and high density PCB, crosstalk is to pay special attention, because it has great impact on timing and signal integrity. Her