tcl王牌 进工厂模式（TCL card into the factory mode）.docVIP

tcl王牌 进工厂模式（TCL card into the factory mode） [share] into the data bus 2910G, 2910D, 2910DZ,, 2911DI, 2911Z, 2911DZ, 2913D, 2915DZ, 2916D, 2927D, 2956D, 2965D,, 2975DI, 2980G, 2980D, 2980GI, 2980DB, 2988G, 2988D, 2988DB, 2988DF, 2988DI, AT2911DZ, AT2915DZ, AT2915, AT2927I, AT2939, AT2956, AT2965, AT2956B, AT2975D, AT2975Z, AT2975F, AT2975I, AT2986Z, AT2980D, AT2980DB, AT2988DB, AT2988, AT2988D, AT2986Z, AT2990, AT2990I CPU type: OM8838, TDA8841 Parameters: ordinary remote control to open the cover on the circuit board D04 plug diode (IN4148), surface direction and direction of the same, then press the menu for the two time, you can enter the factory model project (Note: 21 inch adjustment according to beautify the picture button). Note: the PHILPS IIC digital 29 inch movement Number: 133 Brand: TCL Model: N14K6,21A1,21V1,21G6,21V8,21B1,21B2, N21K1, N21K2, N21K3, N21B1L, N21B2, N21B6, N21B6J, N21G6, N21E2 CPU type: TMPA8803, TMPA8809 Parameters: A, boot press host volume size button, the volume is reduced to 0 (dont let go), at the same time by remote control on the 0 key three times, must be completed within 1.5 seconds, you can enter the factory menu. According to B, directly into the factory on the remote look back button. Requirements: according to the method of A to enter the factory after D-MODE, small screen series press 3 button to select the number and set the DMODE is 01; According to the 6 series of large screen digital keys to select and set FACT to open . After you can use the remote control on the back button to enter or exit the menu directly. Exit C, factory pattern: In the method of the B case by remote control on the back button can be directly from the factory model; when debugging the FACT is set to off, that is before the factory need to set FACT to off, can be directly shut down. Note: Leroy: Toshiba super single chip S12 core Number: 129 Brand: TCL Model: AT3416D (F), AT3460D, AT3480DZ, AT3480GI, AT3486DI, AT3486DZ, AT3488DZ,