手机cpu焊接（Mobile phone CPU welding）.docVIP

手机cpu焊接（Mobile phone CPU welding） In the daily maintenance of mobile phone, almost every day, maintenance personnel are required to remove the CPU power supply with glue IC, we believe that in the disassembly of components of this type also summarizes many good experiences and methods, but after removal of IC is good or bad, the motherboard is broken is always our worst fears. Below I will introduce myself in the maintenance work to summarize some of the demolition of adhesive element by laughing more experience, dedication to you, in order to initiate. Remove adhesive IC: I is doing method (i.e. without solder paste and rosin), with PHILPS 9a9 CPU removal as an example, the board will be placed in the folder on the working platform, the temperature of the hot air gun to remove 2800C, air max, loose head, with the pin rotates around the distance of CPU welding blow 5cm, see CPU around the small element activity, with a knife gently from around the CPU to the bottom of the CPU insertion depth of 1-1.5mm, every 4-6mm distance is inserted, so the CPU will emerge with the edge ball. This is crucial, because CPU does not want to insert around immediately remove the CPU, but the change of temperature and to view the CPU stuck around the CPU glue and small components as CPU together with the removed, as long as the ball can shun knife out, should immediately lift air gun to a distance of more than CPU8mm, according to the picture the soft and hard surface smoothness, can roughly estimate the temperature and the degree of CPU rubber wheel, adjusting the air gun distance from CPU, so as to avoid high temperature damage CPU. When out of the ball is smooth, the available surgical blade light pry around CPU, efforts must be small, slightly to side movement, crow on the other side, cyclic operation; CPU has big movement, one can remove the CPU, the whole process should be completed in 4 to 5min. Dont take this IC, act with undue haste, 95% is good, and the possibility of breakin