氧化石墨烯不饱和聚酯原位复合材料的性能研究.pdfVIP

缁濈紭鏉愭枡 2012 锛?5(5) 闆 鍦嗙瓑锛氭哀鍖栫煶澧ㄧ儻/涓嶉ケ鍜岃仛閰師浣嶅鍚堟潗鏂欑殑鎬ц兘鐮旂┒ 5 姘у寲鐭冲ⅷ鐑?涓嶉ケ鍜岃仛閰師浣 澶嶅悎鏉愭枡鐨勬€ц兘鐮旂┒ 闆 鍦嗭紝鍚 寤猴紝鍗㈠嚖鑻憋紝鑳¤垝榫 锛堟鏋楃悊宸ュぇ瀛 鏈夎壊閲戝睘鍙婃潗鏂欏姞宸ユ柊鎶€鏈暀鑲查儴閲嶇偣瀹為獙瀹わ紝骞胯タ 妗傛灄 541004锛 鎽樿锛氶噰鐢ㄥ師浣嶈仛鍚堟硶鍒跺浜嗘哀鍖栫煶澧ㄧ儻/涓嶉ケ鍜岃仛閰紙GO/UP 锛夊鍚堟潗鏂欙紝鐮旂┒浜咷O 鍚噺瀵瑰鍚堟潗鏂欏姏瀛︽€ 鑳姐€佺‖搴︺€佹懇鎿︾（鎹熸€ц兘鍜岀數鎬ц兘鐨勫奖鍝嶏紝骞堕噰鐢⊿EM 瑙傚療浜嗗鍚堟潗鏂欑殑纾ㄦ崯闈㈠舰璨屻€傜粨鏋滆〃鏄庯細褰揋O 鍚噺 涓?.50% 鏃讹紝澶嶅悎鏉愭枡鐨勫啿鍑诲己搴︽彁楂樹簡14.69% 锛涘綋GO 鍚噺涓?.25% 鏃讹紝澶嶅悎鏉愭枡鐨勫集鏇插己搴︽彁楂樹簡 13.89%锛涘綋GO 鍚噺涓?.75%鏃讹紝GO/UP 澶嶅悎鏉愭枡鐨勪綋绉（鎹熺巼闄嶄綆54.7% 锛屼笖瀵瑰鍚堟潗鏂欑數鎬ц兘褰卞搷涓嶅ぇ銆 鍏抽敭璇嶏細鍘熶綅鑱氬悎锛涙哀鍖栫煶澧ㄧ儻锛涗笉楗卞拰鑱氶叝锛涙€ц兘 涓浘鍒嗙被鍙凤細TM215 鏂囩尞鏍囧織鐮侊細A 鏂囩珷缂栧彿锛?009-9239锛?012 锛?5-0005-04 Property Study of Graphene Oxide/Unsaturated Polyester In-situ Composite Lei Yuan, L眉 Jian, Lu Fengying, Hu Shulong (Key Laboratory of New Processing Technology for Nonferrous Metals and Materials, Ministry of Education, Guilin University of Technology, Guilin 541004, China) Abstract: A graphene oxide/unsaturated polyester(GO/UP) composite was prepared by in-situ polymeriza- tion. The effects of GO content on the mechanical properties, hardness, friction and wear properties and electrical properties of the composite were studied, and the morphology of worn surface were observed by SEM. The results show that when the GO content is 0.5%, the impact strength of the composite in- creases by 14.69%; when the GO content is 0.25%, the flexural strength of the composite increases by 13.89%; when the GO content is 0.75%, the wear rate of the composite decreases by 54.7%, and the GO has little effect on the electrical properties of the composite. Key words: in-situ polymerization; graphene oxide; unsaturated polyester; properties 0 寮 瑷€ 鏂欙紝鎻愰珮鑰愮儹鑰愮（鎬э紝