循环水开车（Circulating water drive）.docVIP

循环水开车（Circulating water drive） The long-term parking circulating water system and drive 7.1.1 driving conditions 1) dosing system and side filtering system has been completed repair. 2) cooling tower fan, circulating pump pumps, valves, water pipeline circulating water and the heat exchanger has been completed repair. 3) power supply, power meter has the transmission conditions. 4) calibration. 5) cleaning agent, pre coating agent, corrosion inhibitor and bactericide chemical has arrived at the scene. 6), water absorption tower basin have been cleaned. 7) water purification plant has a normal car, to supplement the water circulating water, enough qualified. 7.1.2 drive program 7.1.2.1 hydraulic flushing water circulation system 1) closed under the tower tank and sump drain valve, suction tank to the water, the water turbidity is less than 5ppm, the total Fe 3mg/l (Fe). 2) open cooling tower bypass valve and the circulating pump circulating valve, close the drain valve. 3) when the circulating water sump level reaches the high level (Yi Liu), according to the program start circulating water pump P-06001B, a circulating water circulation valve of circulating water pump, to adjust the water flow rate of not less than 8000m3/h, to ensure that the irrigation flow rate in 2-3m/s (from the pump attention after the circulation water system exhaust). 4) during the cycle, every 4 hours of a circulating water turbidity and total Fe, when the turbidity is greater than 20ppm, the total Fe is greater than 5mg/l, the maximum water and sewage. 5) when flushing backwater turbidity lower than 20mg/l, the total Fe is less than 5mg/l and keep stable, the circulation water system of qualified flushing. 6) open the bypass valve closed valve tower, cooling tower, water washing tower for filler, turbidity stable until the flushing water is no longer rising when the washing is finished packing. Stop circulating pump. 7) the tower basin and suction as the water in the pool, artificial clean