搭设方案（Erection scheme）.docVIP

搭设方案（Erection scheme） Jiangsu Huayu lamps Co., Ltd. 8# industrial workshop project was built by China Fifth Metallurgical Construction company. The project is located in Danyang province Jiangsu City Picheng town. Engineering construction unit: Jiangsu Huayu lamps lanterns Co., Ltd., design unit: Jiangsu Su Tong architectural design consultant Co., Ltd., which is under the supervision of Danyang construction supervision center. The construction area of this project is 10056M2, the frame structure, the ground two floors. Building a total length of 84.5M, width of 60M, total building height of 13.3M (plus or minus zero up to the top of the parapet). In order to meet the main structure and exterior decoration construction requirements, ensure the project of Danyang city standard qualified site requirements, especially the preparation of the plan, construction and acceptance as the basis. Two, overall planning According to the construction requirements, in accordance with national standards and acceptance of the relevant provisions of the industry. Prepare the following plans for the scaffolding of this project. Because of the height of the building is not too high, to the parapet height of only 13.3M. Therefore, the erection method of floor scaffolding is adopted. Three. Material requirements 1. steel pipe material: The steel pipe material must be A3AY3 and conform to the YB243-63 standard. The steel No. 3 in the GB700-79 requires a diameter of 48 millimeters, a wall thickness of 3.5 millimeters, a steel tube of 3.84 kg in length and a weight of 1000 millimeters per millimeter. No cracks, deformation, denting, bending and severe corrosion. 2. fastener material: Fastener material according to GB968-67 ordinary carbon structural steel technical conditions in the provisions of A3 steel. The use of dust, cracks, deformation, rivets, stripping or damage, screws are slippery, and so on, will be prohibited. The fastening force of the fastener is 39.2-49 M. m.. The clearance