建筑工程钢筋计量方法（The construction of reinforced measures）.docVIP

建筑工程钢筋计量方法（The construction of reinforced measures） .txt measurement method of steel construction The construction of reinforced measures Steel reinforcement calculation method The first chapter beam The first section of the frame beam First, a cross bar calculation 1, through the upper band The upper perforated rebar (rib 1 = length on long) through cross span long + two end bearing anchor value 2, end bearing negativereinforcement End bearing negativereinforcement length: the first row of Ln/3 + end support anchor value; The second row is Ln/4 end support anchor value 3, lower reinforced The reinforcement length = span long + about bearing anchor value Note: whether or not the lower reinforced points, the calculation results are the same, so we can not input row information in the lower part of the beam longitudinal reinforcement mark. More than three kinds of steel are all related to the bearing anchorage problems, then, in the software is how to realize the judgment about the bearing anchorage in 03G101-1? We now summarize the above three types of steel bearing anchorage judgment: Bearing width is greater than or equal to Lae and 0.5Hc + 5D, Max{Lae, 0.5Hc + straight anchor, 5D}. The anchor end bearing steel bar = bearing width less than Lae or less than 0.5Hc + 5D, Max{Lae bending anchor, bearing width - protective layer +15d}. The middle bearing anchor bar = Max{Lae, 0.5Hc5d} 4, waist rib Structure: reinforced structural reinforcement length = span length + 2 * 15d Torsion bars: algorithm with perforated rebar 5, reinforcement Length of reinforcement (Liang Kuan = 2 x protection layer) + 2 * 11.9d (seismic hook value) + 2D Brace root number: if we do not have in the flat cloth reinforcement spacing input method given in the stretch, then stretch the root number (root number /2 = stirrup) * (structural reinforcement root number /2); if the reinforcement reinforcement spacing, reinforcement that root number = length / reinforcement reinforcement spacing. 6, stir