机械回填土工艺标准（Standard for mechanical backfill）.docVIP

机械回填土工艺标准（Standard for mechanical backfill） 1-5, mechanical backfill process standards (105-1996) 1, the scope of this process standards applicable to industrial and civil buildings and structures, large area leveling site, large foundation pit and pipe ditch backfill. 2???????? preparation of construction materials and major equipment: 2.1? 2.1.1? Gravel and sand (using sand and silty sand should be made with the consent of the design units) and blasting ballast can be used as a filler, below the surface. The maximum diameter of each layer shall not exceed the paving thickness when 2/3 or 3/4 (using the vibration roller, when the moisture content should be consistent with the provisions). 2.1.2 cohesive soil should be checked for its moisture content and must be within the design control range before use. 2.1.3? Saline soil is generally not available. But the filling does not contain salt, crystal, salt block or salt bearing plant rhizome, and conforms to earth and blasting engineering construction and acceptance specifications, schedule 1.8 of the saline soil can be used. The main equipment: 2.1.4? 2.1.4.1? Shipment: earthmoving machinery shovel, dump trucks, bulldozers, scrapers and dump trucks etc.. 2.1.4.2? Rolling machinery: flat grinding, kneading and vibrating. 2.1.4.3? The general machine has a frog or a diesel rammer, trolley, shovel (flat or tip), 2m, No. 20, steel wire hose etc.. 2.2 operating conditions: 2.2.1?? according to the engineering characteristics, backfill material type, density requirements and construction conditions, before construction should be reasonably determined, backfill material moisture control, virtual paving thickness and the parameters of compaction; the important backfill earthwork, the parameters should be determined by the compaction test. 2.2.2 fill the basement before and after completion of the project has been checked and intermediate acceptance, after qualification, be prepared for concealment and acceptance procedures.