模拟地与数字地（Analog to digital）.docVIP

模拟地与数字地（Analog to digital） Analog and digital, and eventually received a piece of, then why do you want to analog and digital? This is because although it is interlinked, but the distance is long, it is not the same. The voltage at different points of the same wire may be different, especially when the current is large. Because of the resistance of the wire, the voltage drops when the current flows through it. In addition, the conductor has a distributed inductance, in the AC signal, the impact of the distribution of inductance will show. So we have to divide them into digital and analog, because the high frequency noise of digital signals is very large. If analog and digital are mixed, the noise will be transmitted to the analog part, which will cause interference. If the ground is separated, the high-frequency noise can be isolated by filtering at the power source. But if the two fields are mixed, then the filter is not good. Relating to grounding: digital, analog, signal, ground, DC, ground, ground, or ground ________________________________________ Date of publication: 1234 readers have read this article in September 9, 2005 In addition to the correct grounding design and installation, it is also necessary to correctly handle the grounding of various signals. In the control system, there are approximately the following ground lines: (1) digital: also called logic, is the zero potential of various switching quantities (digital quantities). (2) analog: the zero potential of various analog signals. (3) signal ground: usually the ground of sensor. (4) exchange ground: the ground wire of AC power supply; this kind of ground is usually the place where noise is generated. (5) DC ground: DC power supply ground. (6) shielding ground: also called chassis, in order to prevent static induction and magnetic induction. The above ground handling is an important problem in system design, installation and debugging. Here are some ideas on grounding: (1) one point earthing should