流体（fluid）.docVIP

流体（fluid） The 8. part: this part of chemical unit operation as the key point, is divided into 8 parts The fluid delivery part, a total of 93 questions, 5 questions should be 1 an equipment inlet and outlet pressure meter reading were P1 (g) =1200mmHg and P2 (vacuum) =700mmHg, the local atmospheric pressure is 750 mmHg, while the absolute pressure difference of two (mmHg). A, 500; B, 1250; C, 1150; D, 1900 D 2 can be used for conveying fluid containing suspended matter is (). A, B, plug; stop valves; C, D, A valve throttle valve; 3 Phi mm diameter * wall thickness mm to indicate the specifications are (). A, B, cast iron pipe; steel pipe; C, D, B cement pipe pipe; 4 demolition of the tubular diameter pipeline (usually) connection. A, B, thread; flange; socket type C, D, A welding; 5 centrifugal pump mounting height is limited (mainly). A, to prevent the generation of air binding phenomenon; B, to prevent cavitation; C, limited by the pump head; D, the pump power limit of B The following 6 fluid conveying machinery must be installed in the pressure stabilizing device and heat removal device (is) A, B, centrifugal pump; reciprocating pump; reciprocating compressor C, D, C; rotary pump The 7 conveying paste should be used (). A, B, centrifugal pump; reciprocating pump; C, D gear pump, compressor. C The 8 density of 1000kg/m3 fluid in? 108? 4 of the flow tube, the flow rate of 2m/s, the viscosity of the fluid is 1cp, the Re (). A, 105; B, 107; C, 2? 2? 106; D, 2? 105. D The following statement is correct (9). A, centrifugal fan final pressure is less than 1500mmH2O; B, centrifugal blower, final pressure is 1500H2O~3kgf/cm2, the compression ratio is greater than 4. C, centrifugal compressor final pressure is 3kgf/cm2 (g) above, the compression ratio is greater than 4; D, centrifugal blower, final pressure is 3kgf/cm2, the compression ratio is greater than 4. C 10 centrifugal pump head with the increase of flow rate and (). A, B, C increase; reduction; and constant; D, no