理正边坡水利（Lizheng slope water conservancy）.docVIP

理正边坡水利（Lizheng slope water conservancy） The 5.21 edition, geotechnical calculation in complex soil stability calculation is used, the application of image in the lower reaches of the slope stability calculation of dam stability seepage period, and read data after calculation, found that slope downstream of the dam safety factor of 1.02 smaller than the standard normal operation period of the 1.2, but the situation at all levels of the slope surface slope were slow to 1:3, according to the actual coefficient safety engineering should meet the requirements of 1.2, may I ask what is out of the question, thank you Answer: the stability safety factor is related to the method of calculation, the width of the soil bar, the intensity index of the stratum and the seepage field. You can check the parameters carefully. 2 、 what is the angle of seepage coefficient in seepage analysis software? Answer: I suggest you consult your geological prospecting personnel, design methods, you can request geological survey, given this parameter, specific parameters meaning, detailed consultation with investigators. 3, for the slope stability analysis software input data water: how to determine the slope of low water level, is the lowest water level upstream slope, back water slope, the lowest water level and in relation to the phreatic line? Can you give examples to explain in detail?. Thank you Answer: dam slope low water level and infiltration line does not matter, used to determine the area of alternative bulk density method: below the phreatic line, dam slope low water level above, the sliding force with saturation, severe, anti sliding force with floating weight. 4 excuse me, geotechnical 4.01 edition, slope stability calculation block in the input slope line or sliding surface line, horizontal projection is negative, do not enter, when the negative value of the input, the software changed to 0, what is the reason? Answer: you can look at the prompt, slope line: horizontal input digita