电源避雷器安装方法及要求（Installation method and requirement of lightning arrester for power supply）.docVIP

电源避雷器安装方法及要求（Installation method and requirement of lightning arrester for power supply） Installation method and requirement of lightning arrester for power supply Power source arrester for parallel installation, installation position for a switchboard or switch satellite education section in the classroom (circuit breaker) at the rear end, self tapping screws matched with four sets of M8 plastic expansion and fixed on the wall. Install dimensions (70 * 180) with the corresponding mounting holes on the power arrester to drill on the wall. Lightning arrester of power line is red, the zero line is blue, the cross sectional area of BVR6mm2 multi strand copper wire, wire was yellow and green color, the cross sectional area of BVR10mm2 multi strand copper wire, wire length is less than or equal to 500mm, if the conditions are not up to the standard of less than 500mm can be appropriately extended, but should follow the wire as short as possible the principle of, The corner should be greater than 90 degrees (the arc angle rather than the right angle). One end of the power supply lightning arrester is directly and firmly connected to the connection terminal of the lightning arrester of the power supply. The grounding wire is connected to the independent grounding grid or the ground wire of the three-phase power supply provided by the school. Installation notes: When installing a power arrester, the ground system should be securely connected before connecting to another line. The power supply must be disconnected when installing, and the live operation is strictly prohibited. The connecting wires must meet the requirements. The lightning arrester doesnt need special maintenance. It only needs to check whether the connection is loose or not, and whether the working condition indicator is normal or not. When the working status indicator is green, it means that the lightning arrester is working properly. When the red light occurs, it means that the lightning arrester is damage