电缆预留系数（Cable reservation factor）.docVIP

电缆预留系数（Cable reservation factor） Reserved general cable. The most commonly used. Is reserved for each cable terminal One point five M, the middle head reserved Two M. Cable into the power distribution cabinet reserved Two M. Cable from Outside into the building reserved Two M. Cable import substation reservation One point five M. Enter the cable trench or lead or lead under reserved hanger One point five M. Cable bending According to the engineering calculation and the length of the length of the reservation 2.5% Plan to take. Note that. If the cable duct laying. We theoretically do virtual cable in the tube are Is straight, not bent, so it can not take into account 2.5% Bending reserved length. The additional length of cable laying Serial number project Reserved length ( additional ) Explain One Cable laying, waveform curvature, cross relaxation degree 2.5% According to the cable length calculation Two The cable into the building 2.0m Minimum specification Three On cable into the trench or hanger at ( lower ) Reserve 1.5m Minimum specification Four Substation, line line 1.5m Minimum specification Five Power cable terminal 1.5m Minimum maintenance allowance Six Cable joint box Both ends of each stay 2.0m Minimum maintenance allowance Seven Cable control, protection screen and simulation etc. high + wide According to the size of the disk Eight High voltage switch cabinet and the low-voltage power distribution panel and box 2.0m Dish out line Nine Cable to the motor 0.5m Starting from the motor terminal box Ten Transformer 3.0m Starting from the floor Eleven The cable around the beam column length etc. According to the actual calculation According to section is around the calculated length increase Twelve Elevator cable and cable rack fixed Each 0.5m Minimum norm Calculation formula of cable installation quantity: L= Sigma Horizontal length + Vertical length + Various reserves Length) x 1+2.5% Cable Coefficient of bend bend residual . according to National unified ins