端头切顶液压支架（End cutting hydraulic support）.docVIP

端头切顶液压支架（End cutting hydraulic support） The end of the L type base top cutting hydraulic support Fully mechanized working face belt trough ends are arranged at the Department of transport before and after the head and tail of loader equipment, pedestrians, ventilation and handling of the throat, the management and support of quality is key to the working face safety degree of normal production, working face. Yunhe Coal Mine fully mechanized working face belt crossheading cutting top line generally supporting the width of 1.6 meters to 2 meters, has been using the word beam with single hydraulic support and roof cutting on the column (single prop called the pillar of the closed), column spacing of 0.5 meters, the general need to make five group of column ten tree single prop to strengthen support, work every two rows in the push pull loader, as a support, back to work. Because of small work space, only two people with the operation, single prop back out must be manually reproduced from the machine out of each branch to operations in more than one hour, the support is restricted in fully mechanized mining face to improve the propulsion speed bottleneck and yield. The need for artificial pillar, closed back, operated by full-time single pillar supporting responsible. A single pillar, beam and column the weight of the shoe are heavier, every time, you need to work to support a good ten monomer, back to the original ten trees from the monomer, the labor intensity of workers. At the same time, monomer supporting strength is low, the supporting effect is relatively poor, repeatedly cut top line falling in the production process, seriously affect production, and even appeared single prop to come up the phenomenon of retracement during roof breakage, may occur even falling, is one of the safe point in the fully mechanized mining. To change this situation, need to use special hydraulic support instead of closed end pillar now. The end hydraulic bracket of each hydraulic suppo