现场测试（Field test）.docVIP

现场测试（Field test） Six 、 field test: 1. Please correct the test procedure of sand filling test. (1) direct the sand filling tube on the test pit, open the sand storage barrel switch, and let the sand flow into the test pit. Until the sand in the sand storage tank is no longer dirty, the switch is closed and the quality of the remaining sand is weighed. (2) the quality of the sand in the lower cone of the sand filling tank shall be calibrated according to the requirements. (3) representative samples were taken from all the excavated materials to determine the water content. (4) take out the sand in the test tube carefully for reuse in the next test. (5) choose the test site and clean it. (6) a hole, remove all loose material chisel. (7) calculation of sand filling density. Answer: the correct test order is: 2, 5,, 6, 1, 3, 7, 4 2, please correct the test procedure (using pressure ring and flow meter) for the asphalt mixture Marshall stability. (1) in the Marshall test head tee anti properly ball, and aligned head load measuring device. (2) start loading equipment so that the test pieces bear load. (3) keep the specimen in a constant temperature tank at the prescribed temperature until the specified time. (4) the flow meter is installed on the guide rod and the pressure head pressure on the light guide tube, the flow meter readings of zero, zero indicator adjustment pressure ring. (5) when the test load reaches the maximum moment, remove the flow meter, and read the pressure ring and flow meter dial indicator readings flow. (6) put the upper and lower head of Marshall tester into the sink or oven. After the same temperature, remove the sassafras and try to clean the inside. Take out the test piece and place it on the lower pressure head. Cover the head and install it on the loading equipment. Answer: the correct test procedure is: 3, 6,, 1, 4, 2, 5 3, please correct the subgrade modulus of resilience on the bearing plate test. The jack loading, preloading to 0.05Mpa, th