现浇箱梁（Cast-in-place box girder）.docVIP

现浇箱梁（Cast-in-place box girder） Cast-in-place continuous box girder construction scheme 1, a brief introduction of the design The upper structure of the bridge is the 4 hole of a (4 * 25m) of cast-in-place prestressed concrete box girder beam, high 1.40M, high 1.0m chamber, bridge length 100m, width 15.0m bridge, about double, single wide beam 7.5m, which Dikuan 3.75m. The bridge and the main line of a plane orthogonal, mostly in the line segment, gentle curve segment after a small part in A=60 and R=60m, located in the longitudinal slope of + 3.8%, - 2.4%, R=2000m vertical curve radius of vertical curve, its two-way cross slope 2% deck transverse slope to spin box girder instead. Double GPZ3DX bridge using single pot bearing, the pier No. 2 pier beam consolidation, No. 1, No. 3 pier with a single pot bearing GPZ6DX. Under the bridge for the geological were 4m thick loam, 5m thick gravel containing cohesive soil and silty sandstone. 2, construction project overview (1) support foundation On the construction of the bridge can be cleaned, leveling, cleaning slag backfill 1m, compacted, and then under the siltstone slag filling to the beam at 1m, when filling the layered paving, layer thickness is 40cm, when filling burying settlement of pile settlement observation, observation once every three days, until the filling one month after the completion of three consecutive times, and the settlement does not exceed 3mm, then uninstall 1m, leveling, compaction, testing requirements and finally laying 10cm thick gravel, pouring 10cm thick C20 concrete as foundation support. See figure 1. (2) scaffording According to the design scheme with full support cast-in-place construction, the construction about framing before and after. At the completion of support foundation construction, setting out of box girder, determining the plane position, in the set up at a predetermined position, the vertical plane steel pipe vertical and horizontal spacing is 80cm * 80cm, web support encrypti