现浇楼板（Cast-in-place floorslab）.docVIP

现浇楼板（Cast-in-place floorslab） Key points of cast-in-place mezzanine floor production A method of making Steel girder, angle purlin, top spot tread plate, and then hit a layer of about 5 cm of cement mortar floor layer The production requirements of steel beam and steel stairs have even before the construction of butt welding The construction cycle, cost advantage, but slightly higher Method of making two Channel based angle auxiliary links, spot rebar, and then hit a layer of about 8 cm of cement mortar pouring layer This cost is slightly low, but slightly longer construction period of about 10 days can only be removed part of the top frame, also need maintenance The design and construction scheme of the cost constitute of the attic floor The attic floor hanging method 1. hanging attic floor, there are three kinds of way, channel, steel, flooring, carpet or tiles (the floor cement watering). 8, note: 1, if you have no confidence on the fixed channel, must be installed in vertical to the position of the rail channel support has rung, in the case of a fixed, not every main keel need channel vertical support, not more than 6 meters under the condition that the side has two or three supporting line. 2, is the two section of the strip itself is not welded, must be long development. 9, if the indoor plane you is not square, but other polygons, should be handled according to the above principle. If necessary, should consult a professional structural engineer. Four construction methods of reinforced concrete, the attic The cast-in-place reinforced concrete, if the original design permits, is suitable. Affordable, reliable quality, long service life. The concrete floor is permanent, average life expectancy is 70 years, so the need to carefully design and layout design of floor, of course here looking for some of the high level design to promote the design capacity of the unit to complete, at the same time as the users to understand their actually how the use of space, if he