轮胎磨损（Tire wear）.docVIP

轮胎磨损（Tire wear） Abnormal wear and early wear of tire The wear of a tire is caused by friction between the tread of the tire and the road surface. Wear and tread formulations, air pressure, speed, Load, use conditions, road conditions and driving methods, or vehicles (four wheel positioning, tire position, etc.) have a great relationship. round The wear of the tire is either large or small, and if it develops to a critical level, abnormal wear will occur. Causes of abnormal wear: - vehicles: failures such as rims, brakes, poor tyres, four wheel alignment, etc.. - tires: tread formulations, low pressure or overload. Preventive measures: - maintain proper air pressure and change position regularly; - minimize emergency starts, emergency brakes, emergency turns and other bad habits. - periodically check the four wheel alignment, brake and rim of the vehicle. Example 1) serrated or stepped wear The zigzag or stepped wear of a tire occurs mainly in a block or horn pattern. The formation of this wear is mainly due to the car As a result of improper vehicle conditions or running habits, the following are the specific circumstances: - Tyre transposition is not done on time; - vehicle suspension or shock absorber system is not good; Improper tire pressure; Sudden braking or acceleration is frequent. Example 2) partial wear of tire - premature wear of tire centres: excessive tire pressure; - early wear of tire shoulders: low tire pressure; - one side of the tire shoulder early wear: vehicle four wheel alignment is bad. Example 3) tire transposition should take into account the wear of the tires The tire transposition is designed to maximize the life of the tire by uniformly wearing all the tires assembled on the vehicle. Tire Life expectancy is affected by many indirect factors (climate, road conditions, etc.) and direct factors (load, tire pressure, four wheel positioning, driving habits) Therefore, it is difficult to determine the time of tyre transposition based on the mile