轴向和径向柱塞泵（Axial and radial piston pumps）.docVIP

轴向和径向柱塞泵（Axial and radial piston pumps） What is the axial and radial piston pump working principle and its application respectively? 2011-3-8 source: Shanghai Beite industrial automation equipment Co., the axial and radial piston pump working principle and its application are what is the volume change of the parallel drive shaft and piston reciprocating in a plunger hole caused by the movement to work. The radial piston pump is a reciprocating motion direction of the piston or plunger of axial piston pump with vertical drive, such as the use of eccentric wheel to drive. Usually the axial piston pump pressure generated by the relatively large, but with small flow pulsation and. The radial piston pump flows relatively larger, and relatively stable, but less pressure. Oil pump principle of piston pump Oil pump plunger pump mechanism includes two sets of precision parts: plunger plunger sleeve (plunger) + (barrel) constitute a plunger (plunger and barrel assembly) (Figure 5-11), a valve (delivery valve) and the oil valve seat (delivery valve seat) is formed by a valve (delivery valve assembly The plunger and the plunger sleeve is a pair of precision parts, the paired grinding are not interchangeable, wear resistance requirements with high accuracy and good smoothness, the radial clearance is 0.002 ~ 0.003mm Cylindrical surface of plunger head chute cut there, and through the radial hole, the axial hole and at the top of the same, the purpose is to change the cycle of oil production; plunger has put into the system, back to the hole, with the pump body cavity at the same pressure oil, pump plunger into the body suit, the application of positioning screw positioning. The different position of the plunger head chute, change the amount of oil in a different. Valve seat and the oil is also a pair of precision parts, after the pair are not interchangeable grinding, and its clearance of 0.01mm. The oil valve is a one-way valve, the pressure in the spring under the action of th