温度测试HeatingTestClauseTableA.PPT

The insulation between the primary circuit and 1 kV hazardous voltage secondary circuit is required to be only basic insulation. (Failure of this insulation must be simulated to see the effect of on LCC). * 附圖一 OUTPUT OVERLOAD TEST P R I S E C L N CONTROL CIRCUIT SECONDARY RETURN OUTPUT OUTPUTS POWER ISOLATING TRANSFORMER LOADHERE TEST CONDITIONS1. INPUT – Normal input voltage2. OUTPUT – Gradually increasing this load by10 % until results acquired or temperature stable REQUIREMENTS? ON POWER ISOLATING TRANSFORMER – Can’t exceed the abnormal temperature limit as defined in standard? ON UNIT – No insulation breakdown, no 　　any hazards * 附圖二TRANSFORMER OVERLOAD TEST TEST CONDITIONS1. INPUT – Normal input voltage2. OUTPUT – Max. output load3. EXTRA CONNECTING RESISTOR　LOAD – Gradually increasing this load by 　10% until results acquired or temperature 　stable REQUIREMENTS? ON POWER ISOLATINGTRANSFORMER – Can’t exceed the abnormal temperature limit as defined instandards for details? ON UNIT – No insulation breakdown, no any hazards P R I S E C L N CONTROL CIRCUIT EXTRA CONNECTING ADJUSTABLE RESISTOR SECONDARY RETURN OUTPUT OUTPUTS POWER ISOLATING TRANSFORMER * END OF THE DAY Speaker Notes: Explain the different sections/modules of the manual. An automated teller machine which is fitted in a wall of the building structure is a good example of “Equipment for Building-in”. Components should not be mixed with this. * 2.能量洩放測試 Energy Discharge Test (Clause 2.1.1.7) 1). 以標示之最高輸入電壓值與頻率測量值。 2). 插頭兩端間電位, 於停電一秒後需小於原電位之 37%. * 附圖 P R I S E C TEST UNIT L N OUTPUTS SCOPE INPUT TEST CONDITIONS1. INPUT – Normal input voltage2. OUTPUT – Worse output load3. Switch OFF REQUIREMENTS1 sec, 37% Vinput * 3.安全電位測試 SELV Reliability Test (Clause 2.2.3) 機器正常動作時與異常(single fault)情況下，任何使用者可觸及之兩端點間不可超過 30 Vrms, 42.4 Vpk or 60 Vdc 持續 0.2 秒 (可single fault)。 * 附圖 TEST CONDITIONS1. INPUT – Normal input voltage2. OUTPUT – Normal max l