sht10和PIC单片机程序.docVIP

#include pic.h#include math.h #define?DATA?? ?RC7 //定义通讯数据端口#define DATA_IO TRISC7 //用于设置IO状态#define?SCK?? ?RC6 //定义通讯时钟端口 #define noACK 0?????? //继续传输数据，用于判断是否结束通讯#define ACK?? 1?????? //结束数据传输； ??????????????????????????? //地址? 命令#define MEASURE_TEMP 0x03?? //000?? 00011#define MEASURE_HUMI 0x05?? //000?? 00101 void init_uart(void);void s_connectionreset(void);void s_transstart(void);char s_measure(unsigned char *p_value, unsigned char *p_checksum, unsigned char mode);char s_write_byte(unsigned char value);char s_read_byte(unsigned char ack);void calc_sth11(float *p_humidity ,float *p_temperature);float calc_dewpoint(float h,float t);void delay (unsigned int time); ?union{ unsigned int i;? float f;}humi_val,temp_val; //定义两个共同体，一个用于湿度，一个用于温度 /*******************************************************************************延时 1MS 带参数(int)子程序*******************************************************************************/void delay (unsigned int time){?unsigned int a,b;?for(a=0;atime;a++){??for(b=0;b88;b++);?}} //----------------------------------------------------------------------------------void init_uart(void)//----------------------------------------------------------------------------------// 端口初始化{?TRISC7=0;?TRISC6=0;} //----------------------------------------------------------------------------------void s_connectionreset(void)//----------------------------------------------------------------------------------// 连接复位;//?????? _____________________________________________________???????? ________// DATA:????????????????????????????????????????????????????? |_______|//????????? _??? _??? _??? _??? _??? _??? _??? _??? _??????? ___???? ___// SCK : __| |__| |__| |__| |__| |__| |__| |__| |__| |______|?? |___|?? |______{? ? unsigned char i; ? DATA=1; SCK=0;??????????????????? //准备? for(i=0;i9;i++)????????????????? //DATA保持高，SCK时钟触发9次，发送启动传输，通迅即复位? { SCK=1;??? SCK=0;? }? s_transstart();?????????????????? //启动传输} //-------