正负触发（Positive and negative triggering）.doc

正负触发（Positive and negative triggering） The central locking trigger mode and the connection judgment: - 1. negative trigger judgment: the test pen clip is connected with the ground (ground). Two control lines end touch stylus test lock, if the lock, the two line is a negative trigger control line lock. - B. is the trigger mode: judgment test pen clamp end is connected with the power supply, two control lines end touch stylus lock, if the lock, the two line is the line trigger control lock. - 2. positive and negative trigger judgment: if using the above two methods are used to judge the lock, the positive and negative trigger mode. - 3. single series negative trigger judgment: with only one test pencil line lock, then find no lock line, and cut the line will unlock. - 4., positive and negative trigger and positive loop judgment is the same, some people say. A positive or negative trigger does not necessarily have a positive loop. They judge the method is to unlock or lock the lock, there are two with positive line, disconnect, these two can be positive and negative trigger, but not necessarily with positive loop. In the break line, and then to lock in respectively a positive charge and then look at the lock is opened or closed, it sure is not positive loop. -; 5. double potential trigger: he is in the same line will have two action at a time of high voltage and low voltage (shidianbi clip negative, a test in the control box, if a line appears on or off, meet again, open or closed, there are two potential negative contact) such as: pineapple car control switch 3 wire socket of high voltage and low voltage line two, a control input line. 6. single negative trigger (judgment method is the same line of a negative action once again to a negative and a lock) - repeatedly switch lock. 7., single line series negative trigger and single line negative trigger difference is big, single line series negative trigger is to disconnect the central control line, to the host power supp