安装知识（Installation knowledge）.doc

安装知识（Installation knowledge） Installation knowledge.Txt First, in the electrical installation works, the copper core cable terminal in what circumstances need to be calculated, is not in accordance with the cable cross-section size to be divided? How is the amount of work calculated? In which case is the cable head calculated and under what circumstances do you press the copper terminal? Answer: copper core cable head is determined according to the manufacturing process, and its process is divided into: dry bag type, pouring type, heat shrinkable type. But sometimes the cable head is only a simple crimping, at this time can not apply the cable head production, but should press the copper terminal calculation. National Atlas to see, there are a variety of instructions and instructions. The actual construction may be different from the atlas, but can be roughly out of that process. When the two ends of the cable are connected with the tray, it is necessary to calculate the copper core cable end head, which is divided into two sets according to the sectional size of the cable, a cable and a terminal head. The middle head is 1 per 250m, the budget is not in general, and the actual visa is issued at the time of occurrence Measurement of cable head generally refers to the first cable cable into the cabinet, according to the cable section division, division principle is the largest single core sectional area shall prevail. Two, apply in the sitting closet installation quota items is included in the price of the angle valve. Apply the washbasin whether quota items include installation angle valve and faucet installation, angle valve and water prices are also included in the inside diameter? Answer: each local ration have, in fact no matter where the quota, quota items you should use on your form a picture, look at the composition and consumption quantity inside the machine, you will be clear to your question. Three, 7 core control cable laying can be applied to 35 square me