注塑机操作中应注意的几点（Points to be noticed in operation of injection molding machine）.docVIP

注塑机操作中应注意的几点（Points to be noticed in operation of injection molding machine） In the procedure of injection molding machine, injection molding machine production seriously implement the rules of operation for the production equipment and personal safety needs, is a necessary means to ensure the quality of molding products Dakumar injection molding machine. Perform the operation of the program requirements, that is, the best maintenance of the production equipment. Therefore, the operator should keep in mind the production process of the injection molding machine before the job, and must conscientiously implement the procedures stipulated in the operating procedures and requirements. 1. Preparation before production Clean the surrounding environment of production equipment, and do not allow to keep any articles which have nothing to do with production. Production equipment should be cleaned and cleaned, and oil and dirt should not be found in each part. The injection moulding machine, the tie rod and the injection seat slide rail must be clean as new, and then coated with a layer of lubricating oil. The tools for production and use are clean and sanitary, and put in order. Check all parts of the safety protection device is in good condition. Check that all kinds of safety protection alarm devices can work correctly when emergency stop is conducted. The safety door should be left and right slide, and the stop position of open and close should be in proper contact with the limit switch. Check that the screws and nuts of each part are loose, and make sure the connection between the connecting parts is firm. Inspect the control switch, button and handle, no damage, operation should be flexible, the switch should be in the off position. Check the circuit connection and grounding wire loosening. The oil tank and check the hydraulic transmission system, the liquid level should be standard in the oil show high; check the hydraulic oil quality, should be cleaned free of impuri