pc3000（pc3000）.doc

pc3000（pc3000） The classification of hard disk faults can be divided into two categories, namely, soft and hard faults. The classification of academic circles is complicated, and it is not easy to remember, and the practicability is not strong. The author has many years of data recovery experience, first came to the computer clinic, especially for years to meet the conventional hard disk failure to do a statistics and classification, all users in case of hard disk failure can be corresponding to the phenomenon of the first hard disk fault. Head damage, head damage is a common fault of the hard disk, especially for IBMs later products. The temperature is too high, the heat dissipation problem of hard disk was IBM to the tomb. The typical phenomenon is: head damage not through self boot, and because of the hard disk cannot seek a regular click, click sound. Some laptop hard disk sounds will be small, close to listen to hear. In this case, if the data of the hard disk is important, the power should be switched off immediately. Because the head of the head is damaged, the wobble back of the head arm may scratch the disk and cause numerous data recovery. At this point should find a powerful data recovery company, do not casually get the computer city pavement. Now, the domestic data recovery industry practitioners uneven. As we all know, the hard disk can only be opened in 100 or more pure rooms, and replace the magnetic head. If you disassemble the hard disk in the usual environment, it will cause the disk to become gray and unable to recover the data. Two. Motherboard damage, if the hard disk motherboard burned, the most common performance is that after the power, there is no response. The user can hold the hard disk in his hand and feel if it is turning. If it is a notebook, the hard disk is close to the hard disk to hear if it has a rotating sound. You can also see whether the components on the board have obvious signs of burns. If the hard disk data corruption is no