三相桥式半控.docVIP

目 录 摘 要 .......................................................1 ABSTRACT .......................................................2 第一章 绪论 ....................................................3 1.1电路结构 .................................................3 1.2 工作原理 .................................................4 1.3二极管的作用 ..............................................5 1.4区别...................................................... 6 第二章 建模与仿真...............................................7 2.1 建模 .....................................................7 2.1.1三相桥式半控整流电路的建模与封装 ....................7 2.1.2 同步电源与6脉冲触发器的建模与封装 ..................8 2.1.3 三相桥式半控整流电路的建模与参数设置................ 9 2.2 仿真.................................................... 10 2.2.1 电阻性负载的仿真结果 ...............................10 2.2.2 阻感性负载的仿真结果 ...............................11 第三章 结论 ..................................................13 3.1电阻性负载的结论分析 ....................................13 3.2阻感性负载的结论分析 ....................................13 致谢 ..........................................................14 参考文献 ......................................................15 摘 要 本设计使用MATLAB仿真的方法，通过改变电路的相关参数和不同性质的负载，观察其工作情况，并且进行对比分析与研究，熟悉三相桥式整流电路的工作原理、输出电压及电流波形；掌握晶闸管在电阻电感性负载以及不同控制角下的工作情况。三相桥式整流电路的移相范围为0-180°，通过仿真可知，三相桥式整流电路在电阻性负载和阻感性负载的情况下，其触发角为30°和120°时的波形与理论波形相符合。 关键词 电阻电感性负载；三相桥式半控；晶闸管 ABSTRACT This design using MATLAB simulation method, through the change of the circuit related parameters and different nature of the load, observe the conditions, and comparison analysis and research, familiar with three-phase bridge rectifier circuit principle of work, output voltage and current waveform; Master thyristor resistance inductive load, and in different control Angle of work. Three-phase bridge rectifier circuit phase shifting of the range of 0-180 °, through the simulation, it is known that the three-phase bridge rectifier circuit in the resistive load and resistance to the perceptual load, its triggering Angle for