硬盘异响维修（Hard knock maintenance）.docVIP

硬盘异响维修（Hard knock maintenance） Im here to talk about simple working principle of hard disk: disk power spindle motor speed, the control chip to control the hard disk drive arm corresponding action to complete the data read and write operations. High speed spindle motor is working at a constant speed, if the hard disk supply voltage is too large, it will cause the hard drive speed change, then there will be magnetic arm positioning or error, caused by normal read data or hard disk damage increase. The host read and write data when needed, only need to send a command to read and write files to the hard disk, hard disk is specific how to read and write their own implementation, these operations are opaque to host. A normal voice will obviously general hard at boot time, this is due to the hard disk in the power, the voice coil motor will drive the hard disk from the stopper (hard disk power head parking position) opened and moved over to the disc a few tenths of microns, the whole process will form a sound. When the hard disk head left stopper suspended in the disc over later, the sound will be weakened or disappeared, this is the reason why most of the hard disk at boot time will send a clear sound (actually all disks are sound, but according to their different types of motor, the size of the non noise index the same, some easy to be aware that some people is not easy to detect, ear only) these are normal phenomena. But if the boot after the hard disk will burst obviously have certain rhythm KaKa sound, but in most of the time will not appear in this case, it is very likely to be hard to have or will sign of trouble. Because of the hard disk when a normal reading sound is continuous and uniform, and in one sector appear, hard disk bad sectors, head damage of circuit board fault, it will be a different sound and sound regularity is very strong, especially in the case of increasing the noise we read a particular a file or a particular program, it can be assumed that the