Cisco流量工程的配置.docx

Cisco流量工程的配置配置要素如下：配置IGP-TE，使IGP能够支持opaque-lsa；配置路由器支持TE功能，即全局模式下使能流量工程；配置对应物理接口支持TE功能，即接口模式下使能流量工程；配置TE隧道。如下图拓扑，R1、R2和R3互连，从R1建立一条到R3的TE隧道，其具体的配置如下，在此以R1为例对其配置进行关键注释：[R1]R1# R1#show run Building configuration... Current configuration : 1816 bytes! version 12.4! hostname R1 ! mpls traffic-eng tunnels /*全局模式下使能mpls-te功能*/! interface Loopback0 ip address 202.1.1.1 255.255.255.255 ! interface Tunnel1 /*配置隧道tunnel1*/ip unnumbered Loopback0 /*配置该隧道ip地址，也可以使用ip address方式配置隧道ip地址*/tunnel destination 202.1.1.3 /*配置该隧道的目的地址*/tunnel mode mpls traffic-eng /*配置隧道的模式为mpls-te*/tunnel mpls traffic-eng autoroute announce /*配置该隧道的自动路由功能*/tunnel mpls traffic-eng priority 6 6 /*配置该隧道的优先级*/tunnel mpls traffic-eng bandwidth 3000 /*配置该隧道的带宽*/tunnel mpls traffic-eng path-option 16 explicit name t1 /*配置隧道的显示路径*/tunnel mpls traffic-eng record-route /*配置隧道记录标签信息*/! interface Ethernet4/0 ip address 80.1.2.1 255.255.255.0duplex halfmpls traffic-eng tunnels /*接口模式下使能mpls-te功能*/ip rsvp bandwidth 10000 /*配置接口的总te带宽*/! router o 0.0.0.255 area 0network 202.1.1.1 0.0.0.0 area 0 ! ip explicit-path name t1 enable /*配置隧道使用的显示路径*/next-address 80.1.2.2next-address 80.2.3.2! end R1#[R2]R2# R2#show run Building configuration... Current configuration : 1495 bytes! version 12.4! hostname R2 ! mpls traffic-eng tunnels! interface Loopback0 ip address 202.1.1.2 255.255.255.255 ! interface Ethernet4/0 ip address 80.1.2.2 255.255.255.0duplex fullmpls traffic-eng tunnels ip rsvp bandwidth 10000! interface Ethernet4/1 ip address 80.2.3.1 255.255.255.0duplex halfmpls traffic-eng tunnels ip rsvp bandwidth 15000! router o 0.0.0.255 area 0network 80.2.3.0 0.0.0.255 area 0network 202.1.1.2 0.0.0.0 area 0 ! end R2#[R3]R3#show run Building configuration... Current configuration : 1423 bytes! version 12.4! hostname R3 ! mpls traffic-eng tunnels! interface Loopback0 ip address 202.1.1.3 255.255.255.255 ! interface Ethernet4/1 ip address 80.2.3.2 255.255.255.0duplex halfmpls traffic-eng tunnels ip rsvp bandwidth 15000! route