ghost教程图解（Ghost graphic tutorial）.docVIP

ghost教程图解（Ghost graphic tutorial） Ghost graphic tutorial 1. introduction to Ghost Ghost is a tool for data backup and recovery system, the Symantec Corp launched. The latest version is Ghost10. But since Ghost9, it can run under windows, provides data backup, recovery and automatic timing system backup function. This paper is to introduce the Ghost 8.x series (the latest 8.3), which runs under DOS, can provide a full backup and recovery of system, format the disk file system support including FAT, FAT32, NTFS, ext2, ext3, Linux, swap etc., can also be a full backup of the sector to sector the District does not support. Ghost 8.x series is divided into two versions, Ghost (run under DOS) and Ghost32 (run under Windows), which has unified interface, can achieve the same function, but Windows system under Ghost cannot restore partition where the Windows operating system, so in this case you need to use the DOS version. 2. Ghost start Start Ghost8.0, will appear in Figure picture (Figure 1) Figure Ghost8.0 bootscreen Click on OK, you can see the main menu of Ghost, as shown in figure two. In the main menu, there are the following: (Figure 2) Figure three Local-Partion-To Image backup partition Local: local operation, operation of the local computer hard disk. Peer to peer: the point to point mode operation of the network computer hard disk. GhostCast: through unicast / multicast or on the network computer hard disk broadcast mode of operation. Option: some options when using Ghsot, using the default settings. Help: a simple help. Quit: exit Ghost. Note: when the driver is not installed on the computer network protocol, Peer to and peer GhostCast option will not be available (in the DOS are generally not installed). 3. use Ghost to operate on the partition Start Ghost, select the Local-Partion operation of the partition. To Partion: a copy of the content of the partition to the other partition. To Image: copy of one or more partitions the contents to a file in the mirror