广东万商律师事务所质量跟踪考核制度.doc

广东万商律师事务所质量跟踪考核制度 为进一步提高本所律师的业务素质，增强服务能力，营造一个执业责任心强的律师团队，现根据我所实际情况，经合伙人会议讨论决定，对全体律师实施年度质量考评办法： 考评时间 我所定于每年1月份对全体专职律师上一年度的工作进行质量考核。 考评人员 成立考评小组，对全体专职律师的工作进行质量考评。考评小组成员：徐志光、张志、张善华、陈小伟、张丽杰。 考评内容 主要从工作业绩、工作能力两方面考核。（详见后附表） 考核与奖励 为了考核能够公平、公正，本所采取个人自评与小组复评相结合的原则，即先由个人进行自评，然后再由考评小组根据自评结果进行复评，确定最终得分。 本所将根据考评结果评出本年度优秀律师一名，并发放奖金3000元以资鼓励。 此办法从即日起开始实施执行。 广东万商律师事务所 二〇〇 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and rete