核电站一回路主管道凸台整体锻造工艺数值模拟.PDFVIP

Hot Working Technology 2014,Vol.43,No.9 核电站一回路主管道凸台整体锻造工艺数值模拟 1,2 2 2 周国华 ， 杨 滨 ， 王胜龙 (1. 宜春学院物理科学与工程学院， 江西 宜春 336000 ； 2. 北京科技大学新金属材料国家重点实验室， 北京 100083) 摘 要：压水堆核电站一回路主管道整体锻造技术越来越受到重视，特别是最复杂的凸台。通过Deform-3D 软件对 锻造过程进行了数值模拟，分析了锻造成形过程中坯料的等效应力、应变。 结果表明：在凸台和主管道连接处的等效应 变最大，易形成开裂。 关键词：凸台； 锻造； 数值模拟 中图分类号： 文献标识码： 文章编号： TG316.2 A 1001-3814(2014)09-0106-03 n Numerical Simulation on Whole Forging Process of Boss in Primary c Coolant Pipes for Nuclear Power Plant . (1. P ZHOU Guohua1,2, YANG Bin2, WANG Shenglong2 g hysical Science and Technology college, Yichun University, Yichun 336000, China; 2. State Key Laboratory For Advanced Metals and Materials, University of Science and Technology Beijing, Beijing 10083, China) r ： Abstract The whole forging technology of primary piping of pressurized water reactor nuclear power station has been 库 o paid more and more attention especially for the most complicated boss part. The forging process was simulated by Deform-3D 例 software. The equivalent strain and equivalent stress of the blank in forging process were analyzed. The results show that the . equivalent strain at the boss and the main pipe joints is the most, which is easy to crack. ： 案 o Key words boss; forging;