建模注意（Modeling attention）.docVIP

建模注意（Modeling attention） 0, the output unit is mm Bonet bridge crack, internal force output unit is KN, the moment output unit KN*m stress output unit Mpa 1, from the CAD to the bridge inside the Bo import section or model, CAD coordinates must be geodetic coordinate system. 2, the bridge inside the global coordinate system is Bo to positive, so when we lose load in the global coordinate system if the contrary we should input negative. 3, from the CAD bridge to Bo guide section, the section in the same layer, different regions with different colors to distinguish the. 4, the use of single phase bridge Bo live load force is not included in the impact coefficient. 5, Bo bridge live load force stage has been included in the shear coefficient of 1.2. 6, calculate the distribution coefficient of bridge deck line distance first distance of the beam transverse force for lever method and rigid crossbeam method to the first beam of deck beam line at the middle distance; for the rigid plate girder deck beam to the first principle for the middle left outer end of the cantilever plate distance is used to determine the various effects in live load online mobile location. 7, when the component is the concrete member, the weight coefficient of input 1.04. 8, through the modified section bridge doctor to modify the section of reinforced, the need to add reinforced check removed, reinforced the need to replace the input in the section can be reinforced to replace. 9, in the construction of input load of construction stage, through the display in the View menu content set will display the permanent load check, so that you can look at the loading position and direction of the input is correct. 10, Bo bridge provides a custom section, but when using a custom section, display and calculation is very slow, need patience. Provide the material library definition 11, bridge Bo, suggest that you defined before a unified model, or copied to other materials on the computer does not recognize t