水泥砂浆面层施工工艺（Construction technology of cement mortar surface course）.docVIP

水泥砂浆面层施工工艺（Construction technology of cement mortar surface course） Construction technology of.1.1 cement mortar layer First, key points of construction (1) before the first paved plastering layer, basic water wet, second days to brush a water cement ratio of 0.4 to 0.5 of the cement slurry with layers, then surface layer with. If the cement layer combined with early brushing, it will not and the bonding between the base layer and the surface layer of the role, but caused the bulge. So, we must do with the brush with glue. (2) the cement ground pressure light three times to survive. Every time the time to master the right hand pressure, to ensure the engineering quality. Light pressure too early or too late will cause the ground sand, ash quality accident. (3) when the ground area is larger, the design requirements of the grid, according to the position and size of the ground grid line, mark the lattice position on the wall or by the city on foot, in the surface layer of mortar scraping rub flat, according to the wall or by foot has divided grid well, first use wood trowel twist a surface layer of a treaty float wide, with iron float first smooth, gently press the light, then the line dividing line on elastic bag, with the ground grid is close to the feet along the line out of joint. The surface layer of cement before the final setting, and then the steel trowel flat light pressure, the seam straightening flat grid. Two, construction preparation (a) material: cement, sand and water The sand used in the sand or coarse sand, mud content should not be greater than 3%. When using stone chips, diameter of 1---5mm, with the amount of powder (mud) is less than 3%, more than the standard by screening, scouring treatment (two) preparation equipment: 1.: mechanical mortar mixer 2. tools: trolleys, scraping bars, wood trowel, iron trowel, trowel, shovels, buckets, small watering can, sieve, brush, broom, long wire brush, wedge, hammer etc. 3. measuring tools: level, scale and