电气《安规》中对验电如何规定（How to stipulate the electric examination in electric safety regulation）.docVIP

电气《安规》中对验电如何规定（How to stipulate the electric examination in electric safety regulation） Provisions on how electricity three, electrical safety in Answer: 1, electricity should use corresponding voltage and qualified contact electroscope, when installing the grounding wire or the grounding switch of each phase is respectively electroscopy. Electrical inspection before, should first test in electrical equipment, confirmed the electroscope good; the test can not be carried out in electrical equipment available when the high voltage generator is good electrical verification. 2, high voltage electricity must wear insulated gloves. Insulated telescopic electroscope rod length should be pulled, electricity grip shall not exceed the retaining ring on the handle should be hand, body and electrical inspection equipment to keep a safe distance. Rain and snow may not be outdoor direct electricity. 3, the test cannot be applied directly to electrical equipment, can indirect electricity testing. Check switch (switch) indicating the changes of mechanical, electrical, instrument position indicator and an indication device, and at least two or more instructions have been corresponding changes occur at the same time, in order to confirm the equipment without voltage; if the remote operation, should also check the isolating switch (switch) on the spot the status indicator, telemetry, remote signals and charged display device instructions for indirect electricity testing. 4, disconnect the device and allow the signal into the interval, often access the voltage meter, shall not be used as no voltage equipment according to the. If the indicator is electric, is banned from working in this equipment. Four, electrical safety to the assembly and disassembly of grounding wire to stipulation Answer: 1, installation of grounding wire must be carried out by two people. 2, when the equipment has identified no voltage, should immediately repair the equipment grounding and three-phase short circuit