电气知识（Electrical knowledge）.docVIP

电气知识（Electrical knowledge） (3) electrical equipment transmission device; (4) the two winding transformer; (5) distribution, control, protection of the screen (cabinet, box) and the base metal frame and operation platform, the metal shell enclosed switchgear; (6) metal frame and reinforced concrete frame indoor and outdoor the distribution device and near the charged part of the metal fence and metal door; (7) AC and DC power cable junction box, terminal box and expander, metal shell and cable metal sheath, metal wire can reach threading pipe, laying cable trough, cable bridge; (8) exposed conductive part of the metal lamp; (9) in the non asphalt floor residents, grounding, lightning line arc suppression coil grounding resistance and grounding system in overhead power line metal tower and reinforced concrete tower, equipped with lightning protection Overhead line tower; (10) the exposed conductive part and support electrical device installed in the power line tower on the switchgear, capacitors and so on; (11) armored control cable metal sheath, non armoured or non metallic sheathed cable idle 1 to 2 core wires; (12) busduct the metal shell; (13) metal box type substation box. The exposed conductive part 2. electrical equipment can be grounded (1) in non conducting places, such as electrical equipment, asphalt and other bad conductive ground wood and insulation of the wall, when the two meet, (a) 4. (3) using non conducting location requirements; (2) in a dry place, AC rated voltage below 50V, the exposed conductive part of DC rated voltage 120V electrical equipment or electrical equipment, but the explosion dangerous places except; (3) installed in the distribution screen, control screen and electrical device of the electrical measuring instrument, relay and other low-voltage electrical appliances such as the shell, and when the insulation is damaged, the support does not cause dangerous voltage of insulator metal base; (4) have been installed in the metal structure