见证取样方法（Witness sampling method）.docVIP

见证取样方法（Witness sampling method） The commonly used building materials witness sampling method summary (steel, concrete, cement, bricks, sand, steel etc.) The acceptance of the reinforcement approach: The reinforced approach, should be in accordance with the existing national standards provisions of reinforced concrete with hot rolled ribbed bar GB1499 extraction specimens for mechanical testing, the quality must comply with the relevant standards and regulations. Inspection method: check the product certification, factory inspection report and the approach reinspection report. Sampling method: according to the same batch, the same specifications, the same stove number, the same date, the same delivery status bar, the weight of each batch of not more than 60t for a test batch, on-site sampling; when less than 60t for a number of on-site inspection, sampling. The sample is divided into two tensile specimens, two bending specimens. The laboratory test, each test should be at least one batch of test tensile specimens, a bending specimen. Specimen length: mechanical specimen length is more than 400mm (400~600mm). (Note: when sampling from any reinforcement end reinforced, interception 500~1000mm then sampling.) Cold drawn steel bar should batch acceptance, each batch of weight is not more than 50t of the same grade, the same as a cold drawn steel bar diameter inspection group. Sampling quantity: two tensile specimens, two bending specimen. Two, steel welding Welded steel in building construction is generally divided into: flash butt welding, resistance spot welding, arc welding, electroslag welding, embedded T type submerged arc pressure welding, gas pressure welding. Sampling method: 1, flash butt welding: in the same working class, completed by the same welder 300, with the same level of the diameter of welded joint of steel bars should be used as a test group. When less than 300 classes in the same joint as a test group. 2, mechanical connection in the same working cla