调音台的使用方法（How to use the mixer）.docVIP

调音台的使用方法（How to use the mixer） How to operate and use the mixer The mixer less channels there are 4 road and 8 Road, 96 road and the maximum number of even more. The mixer for control of each circuit is divided into control and auxiliary control part two. The auxiliary signal is independent of the output port, can realize simultaneous output of two or more in the same mix signal mixer. Each channel has a signal input one or several specifications of the port used to connect the recorder, audio system, such as the synthesizer sampler or audio output, or plug in a moving coil, capacitor microphone etc.. And these KouJin even input is usually a knob, we call the gain button (trim), is used to adjust the input signal, when the signal is too strong when the cut is too weak when the promotion (sometimes gain by a decay button pad instead. When the button is pressed or lifted, the input signal is attenuated to a certain extent) to do. Gain is the first mark, as a sound mixer input signal can be adjusted properly to ensure the mixer lower level processing circuit receives sufficient and clean. When the gain knob is set up, you can use the channel volume fader (or volume knob, the bottom is usually located in the console panel) to determine the channel signal sent to the bus volume. The volume fader is actually an attenuator for the output signal of the channel attenuation. When the bar located on the bottom (or the volume knob located on the left), the signal is infinite attenuation, then the channel has no signal output. At the top of the volume fader, you can find a video (PAN) knob, which is used to adjust the signal in the channel between the stereo speakers about the position. Some table between the volume fader and panpot also designed two buttons: Mute (MUTE) and solo (SOLO) button. Mute button can not move the volume fader can be a signal of the channel in the closed mix bus. When the output volume of the channel has been accurately adjusted and dont want to touch i