基于ansys+workbench的龙门式加工中心横梁的+轻量化设计参考.pdfVIP

机械工程师 MECHANICAL ENGINEER 基于ANSYS Workbench 的龙门式加工中心横梁的 轻量化设计 朱卓， 张功学， 王德雨 （陕西科技大学机电工程学院，西安710021 ） 摘 要:用SolidWorks三维软件建立龙门式加工中心横梁结构的立体几何模型，其中横梁内部的筋板布置采用“O”型筋板， 按照分析方案的设计，将三维模型导入到ANSYSWorkbench中进行静力学分析以及模态分析，分别得到其静变形参数和前 六阶模态振型；通过灵敏度分析得出最终设计变量，就是以横梁上下左右壁厚、中间O型筋板、后壁筋板、两边O型筋板厚度 为设计输入变量；以横梁质量、横梁总变形、横梁一阶固有频率为设计输出变量，得到筋板最优尺寸参数。使其横梁结构总变 形减少16.02%，1阶固有频率提高2.94%，质量减少129.9kg,占比8.3%，实现了龙门式加工中心横梁结构的轻量化设计。 关键词:龙门式加工中心；横梁；筋板；尺寸优化；轻量化设计 中图分类号：TH16 文献标志码：A 文章编号：１００２－２３３３（２０１7 ）06－０005－０4 Lightweight Design of Gantry Machining Center Beam Based on ANSYS Workbench ZHU Zhuo ，ZHANG Gongxue ，WANG Deyu （CollegeofMechanicalandElectricalEngineering,ShaanxiUniversityofScienceandTechnology,Xi’an710021,China） Abstract ： The 3D model of gantry machining center beam structure is established using SolidWorks. The rib layout inside beam is O shaped ribs. According to the design of the analysis program, the 3D model is imported into the ANSYS Workbench for static analysis and modal analysis. The static deformation parameters and the first six modes modal shapes are obtained. Through the sensitivity analysis, the final design variables are obtained. The input variables are the upper and lower beam thickness, the middle O-shaped ribs, the rear wall ribs and the thickness of the O-shaped ribs on both sides of the crossbeam, and the total deformation of the crossbeam. The natural frequency is the designed output variable, and the optimal size parameter of the rib is obtained. The total deformation of the beam structure is reduc