使用盘点盘点操作流程.doc

使用盘点机盘点的操作流程 操作步骤如下： 第一步、选中应用界面的模组，双击右边的“模块进入，打开存货盘点调整单； 第二步、在“仓库”处选择录入盘点调整的仓库或者门店，“描述”处录入本次盘点的相关描述信息，点击保存按钮，备注栏自动带出仓库锁定日期： 第三步、点击传送按钮，这里选择从仓库传送（按数量），对于仓库或门店全盘，一般选择传送从仓库传送（按数量），传送数量0的库存； 如下图： 第四步、点击显示锁定数量按钮，系统弹出确认对话框，点击确认后，则在描述表页的帐面数量列显示出锁定该仓库时刻的帐面数值，同时显示锁定数量按钮变灰；如下图所示： 如果因为某种原因，需要撤消锁定数量，可以通过功能中的撤消显示锁定数量按钮来实现； 注意：在此有记录该“存货盘点调整单”的单号，后面能用到。 第五步、进入模组的模块中，当用盘点机盘点完成后，生成盘点文件，将盘点文件整理成如下格式： 条码 数量 6901769932905 899 2009-09-11 使用盘点机盘点的操作流程 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be car