知识杂文（Knowledge essay）.docVIP

知识杂文（Knowledge essay） Get the hand is simplified good model, simplified structure has good, type analysis has been set, boundary conditions and load conditions have been determined, the calculation is completed, can see the result of teaching and consistent even if it is done. In this process, the learner only learned how to use the program, this process, needless to say, college students, high school students can complete. When doing engineering analysis, the situation is completely different, no one to give you specify the model simplification, analysis type, boundary conditions, the calculation is completed, also need to analyze and evaluate the results. In this process, the use of the program has become one of the lowest part of the whole process of technical analysis. A complete analysis of the engineering process is what? The first problem is proposed, in industrial practice, put forward the question of department is usually the design department or production department, the design department will request for a verification or optimization of a design, the production department will be put forward to analyze and solve the defects or problems appeared in the process of production or use. Usually, due to different division, design or production engineer is no experience in finite element analysis, their questions are vague, for example, the design engineer will ask, in some cases, the design of my security? Production engineer will ask, why this product will be bad? Then is the analysis of the problem, this process is the need for structural analysis and Design Engineer Engineer or production engineer to complete the. A design engineer and production engineers question, first make a preliminary judgment on the issue, what is the type of problem, then carries on the investigation to the problem, make the need for the next phase of the finite element analysis. Next, if you decide to carry out finite element analysis requires more careful analysis, to determine th