调速系统（speed regulating system）.docVIP

调速系统（speed regulating system） Q: the introduction on the development of steam turbine governing system L4 Q2 T Q u%? 3, the first generation of steam turbine regulating system is a mechanical centrifugal regulator, has been 100 years of history. The second generation is the hydraulic control system, around 20s and 30s. The second generation control system adopts mechanical transmission or inductive link. So it can be called the mechanical and hydraulic control system it compared with the first generation of regulation system, in response speed, control precision and reduce the delays have been greatly improved. r _5 I4 [@ - u/, n Y# x By the middle of 50s, before the emergence of the DEH system does not rely on mechanical and hydraulic control system. Then, with the development of digital computing technology and its application in automatic control field, especially the rapid development of computer capacity, speed and reliability, the digital with the computer as the control device to simulate the electrical system as manual backup, control system with DEH * * turbine hydraulic actuator, early DEH system is a small computer based, the microcomputer based K7 W* K C. ); P But with the increasing of unit capacity and improve the system parameters, the response speed, adjust the speed and slow showed great deficiencies. On the other hand, can not modify defect rate of change of speed online also makes the system can not meet the requirements of large power grid system. The third generation of steam turbine governing system is analog electro-hydraulic control system around in 50s. This system adopts the operation function of electrical components have replaced the first and second generation systems in the induction and amplification of mechanical transmission, hydraulic part, while retaining a hydraulic actuator -- oil motive. 2 Q7 C2 `1 a B1], C; S4 (HH7, @ V5? 9 L, I)} Now is not the smaller units or old units may be used in the hydraulic control system and the use