Fanu系统宏程序变量.doc

Fanuc系统宏程序变量 刀具补偿值：用系统变量可以读和写刀具补偿值。 可使用的变量数取决于刀补数，是否区分外形补偿和磨损补偿以及是否区分刀长补偿和刀尖补偿。当偏置组数小于等于200 时，也可使用#2001～#2400。 例：? ????????当执行#1=#4002；时，在#1?中得到的值是17，18?或19。?????????对于不能使用的G?代码组，如果指定系统变量读取相应的模态信息，则发出P/S?报警。 当前位置位置信息：不能写，只能读 ·?第1?位代表轴号（从1?到3）。? ????·?变量#5081~#5083?存储的刀具长度补偿值是当前的执行值，不是后面程序段的处理值。? ????·?在G31（跳转功能）程序段中跳转信号接通时的刀具位置储存在变量#5061?到#5063?中。当G31?程序段中的跳转信号未接通时，这些变量中储存指定程序段的终点值。? ????·?移动期间不能读是指由于缓冲（预读）功能的原因，不能读期望值。 工件坐标系补偿值：工件零点偏移值的系统变量 （工件零点偏移值） the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance w