日本红枫见品种(附图).doc

日本红枫常见品种（图片） 日本红枫存在繁多的变种，目前国外苗圃收集的变种不少于三百种以上。一般按照植物原产地可分为中国鸡爪槭和羽毛槭(AcerPalmatumF.Dissectum)、日本槭(AcerJaponicum)与朝鲜槭(AcerPseudo-sieoldianum、AcerShirasawanum)等三大类。按照叶形可分为鸡爪状、细叶羽毛状、扇形状与变叶状几大类。颜色变化繁多，不乏观赏价值很高的品种。 橙之梦 红舞妓 珊瑚阁 绯红皇后 四季火焰 红丝带 卡苏 千染 蝴蝶 守望 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface and internal cylinder surface height difference, compared with the original values confirm the location