西餐零点务标准服务流程.doc

酒店制度  1 / 40 酒店制度 2 / 40 店 酒店制度 3 /40 酒店制度 4 /0 酒店制度 5 / 40 酒店制度 6 / 40 酒店制度 7 /40 酒店制度 8 / 40 酒店制度 9 /40 酒店制度 10/40 酒店制度 11/ 40 酒店制度 12 / 40 酒店制度 13 / 40 酒店制度 14 /40 酒店制度 15 / 40 酒店制度 16 / 40 酒店制度 17/40 酒店制度 18 /40 酒店制度 19 /40 酒店制度 2 0/ 40 酒店制度 21/ 40 酒店制度 （0） 22 / 40 酒店制度 23 /40 \ 酒店制度 24/40 25 /40 26 /40 酒店制度 27 /40 酒店制度 28 /40 酒店制度 29/40 酒店制度 30/40 酒店制度 31/40 酒店制度 32/40 33/40 34/40 35/40 36/40 37/40 38/40 39/40 40/40 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge readi